B&R Industrial Automation (a Business Unit of ABB) 8EI2X2HWD10.0000-1
8EI2X2HWD10.0000-1
Технические характеристики
| Slots for plug-in modules | 1 |
|---|---|
| Network configurations | TN-S, TN-C-S with grounded star point |
| Напряжение питания | 3x 200 VAC to 480 VAC ±10% |
| Frequency | 50/60 Hz ±4% |
| Installed load | Max. 5 kVA |
| Inrush current | Max. 45 A |
| Switch-on interval | Typ. 60 s |
| Integrated line filter per EN 61800-3, category C3 | No |
| Power dissipation at device nominal power without braking resistor | [(50 + 6.9 * PAVG[kW] + 7.5 * (IAX1[A] + IAX2[A]) + 0.25 * (IBR12[A] + IBR22[A]) + PVSLOT) * 1.1] [W] |
| DC bus capacitance | 470 µF |
| Напряжение питания | 24 VDC ±25% |
| Input capacitance | 5507 µF |
| Current consumption | 1.2 A + current for motor holding brake |
| Quantity | 2 |
| Continuous power per motor connection | 1 / 1 kW |
| Continuous current per motor connection | 2.2 / 2.2 AEff |
| Switching frequency 5 kHz | 75 m |
| Switching frequency 10 kHz | 37.5 m |
| Switching frequency 20 kHz | 18.75 m |
| Starting at 500 m above sea level | 0.22 AEffper 1000 m |
| Peak current per motor connection | 6 / 6 AEff |
| Peak power output | 2.5 kW |
| Nominal switching frequency | 5 kHz |
| Possible switching frequencies | 5 / 10 / 20 kHz |
| Insulation stress of the connected motor per IEC TS 60034-25:2004 | Limit value curve A |
| Overload protection | Yes |
| Short circuit and ground fault protection | Yes |
| Max. output frequency | 598 Hz |
| U, V, W, PE | Male connector |
| Shield connection | Yes |
| With wire end sleeves | 1.5 to 6 mm² |
| UL/C-UL-US | 24 to 8 AWG |
| CSA | 24 to 8 AWG |
| Напряжение питания | Typ. 11.4 V |
| Continuous current | 1.3 A |
| Max. internal resistance | 0.25 Ω |
| Extinction potential | Approx. 30 V |
| Max. extinction energy per switching operation | 1.5 Ws |
| Max. switching frequency | 0.5 Hz |
| Overload and short-circuit protection | Yes |
| Open circuit monitoring | Yes |
| Напряжение питания | Yes |
| Response threshold for open circuit monitoring | Approx. 30 mA |
| Peak power int./ext. | 7 kW / 25 kW |
| Continuous power int./ext. | 150 W / 2 kW |
| Minimum braking resistance (ext.) | 25 Ω |
| Circuit | Sink |
| Input - ACOPOS P3 | Yes |
| Input - Input | Yes |
| Nominal | 5 to 40°C |
| Maximum | 55°C |
| Напряжение питания | Approx. 4 mA |
| Low | <5 V |
| High | >15 V |
| Enable 1 → 0, PWM off | 2 ms |
| Enable 0 → 1, ready for PWM | 0.3 ms |
| Modulation compared to ground potential | Max. ±38 V |
| OSSD signal connections | 0.5 ms |
| Type | EnDat 2.2 |
| Connections | 8-pin female mini I/O connector |
| Status indicators | None |
| Encoder - ACOPOS P3 | No |
| Encoder monitoring | No |
| Max. encoder cable length | 100 mDepends on the cross section of the power supply wires in the encoder cable |
| Load capacity | 300 mA |
| Short-circuit proof | Yes |
| Overload-proof | Yes |
| Signal transmission | RS485 |
| Data transfer rate | 6.25 Mbit/s |
| Max. power consumption per encoder interface | PENCODER[W] = U24V[V] * (IENCODER[A] * 0.7) + 0.5 W |
| Rising edge | <2 µs |
| Falling edge | <1 µs |
| ACP10 | V3.12.1 |
| Hanging vertically | Yes |
| Standing horizontally | In preparation |
| Pollution degree per EN 61800-5-1 | 2 (non-conductive pollution) |
| Напряжение питания | III |
| Degree of protection per EN 60529 | IP20 |
| Storage | 5 to 95% |
| Transport | 95% at 40°C |
| Operation | 5 to 85%, non-condensing |
| Width | 66 mm |
| Height | 374 mm |
| Wall mounting | 258.5 mm (with 8EXA front cover: 261 mm) |
| Масса | 4 kg |