8EI4X5HWTS0.XXXX-1

B&R Industrial Automation (a Business Unit of ABB) 8EI4X5HWTS0.XXXX-1

8EI4X5HWTS0.XXXX-1

Технические характеристики

Slots for plug-in modules1
CEYes
ULcULus E225616Power conversion equipment
EACYes
KCYes
Network configurationsTN-S, TN-C-S with grounded neutral
Напряжение питания3x 200 VAC to 480 VAC ±10%
Frequency50/60 Hz ±4%
Installed loadMax. 10 kVA
Inrush currentMax. 45 A
Switch-on intervalTyp. 60 s
Integrated line filter per EN 61800-3, category C3No
With wire end sleeves0.25 to 2.5 mm²
UL/C-UL-US26 to 12 AWG
CSA26 to 12 AWG
Power dissipation at device nominal power without braking resistor[(60 + 6.9 * PAVG[kW] + 7.5 * (IAX1[A] + IAX2[A] + IAX3[A]) + 0.25 * (IBR12[A] + IBR22[A] + IBR32[A]) + PVSLOT) * 1.1] [W]
Max. cable length100 m
Continuous power4 kW
Напряжение питания4 kW * (Mains input voltage [V] / 400 V)
DC bus capacitance470 µF
Напряжение питания24 VDC ±25%
Input capacitance5500 µF
Current consumption1.2 A + Current for motor holding brake
Quantity2
Continuous power per motor connection2 / 2 / 2 kW
Continuous current per motor connection4.5 / 4.5 / 4.5 Aeff
SIL 2 / PL d / Cat. 3Hardware upgrade 1.10.2.x: 1.501 AHardware upgrade 1.10.3.0 or later: 1.199 A
Switching frequency 5 kHz75 m
Switching frequency 10 kHz38 m
Switching frequency 20 kHz19 m
Starting at 500 m above sea level0.45 Aeffper 1000 m
Peak current per motor connection12.25 / 12.25 / 12.25 Aeff
Peak power output5 kW
Nominal switching frequency5 kHz
Possible switching frequencies5 / 10 / 20 kHz
Electrical stress of connected motor per IEC TS 60034-25Limit value curve A
Overload protectionNo
Short circuit and ground fault protectionShort circuit protection: YesGround fault protection: No
Max. output frequency598 Hz
U, V, W, PEMale connector
Shield connectionYes
Напряжение питанияConfigurableTyp. 11.45 V ± 0.1 V / 5.2 V ± 0.1 V
Continuous current1.3 A
Max. internal resistance0.25 Ω
Extinction potentialApprox. 30 V
Max. extinction energy per switching operation1.5 Ws
Max. switching frequency0.5 Hz
Overload and short-circuit protectionYes
Open circuit monitoringYes
Напряжение питанияYes
Response threshold for open circuit monitoringApprox. 30 mA
Напряжение питанияApprox. 23 V
Peak power int./ext.7 kW / 25 kW
Continuous power int./ext.150 W / 2 kW
Minimum braking resistance (ext.)25 Ω
TypeDigital multi-encoder interface, configurable
Variant2x RJ45, shielded, 2-port hub
Cable lengthMax. 100 m between 2 stations (segment length)
Transfer rate100 Mbit/s
Connections8-pin female mini I/O connector
Status indicatorsNone
Encoder - ACOPOS P3No
Max. encoder cable length75 mDepends on the cross section of the power supply wires of the encoder cable
Load capacityMax. 300 mA
Sense lines2, compensation of max. 2x 0.7 V
Short-circuit proofYes
Overload-proofYes
Signal transmissionRS485
Data transfer rateDepends on the configured encoder type
Minimum2.0 V
Maximum55°C
Max. power consumption per encoder interfacePENCODER[W] = U24V[V] * (IENCODER[A] * 0.7) + 0.5 W
CircuitSink
Input - ACOPOS P3Yes
Input - InputYes
Nominal5 to 40°C
Low<5 V
High>15 V
Напряжение питания7 mA
Rising edge<51 µs
Falling edge<52 µs
Modulation compared to ground potentialMax. ±38 V
mapp Motion5.00.0 and higher
ACP10/ARNC03.14.1 and higher
Hanging verticallyYes
Standing horizontallyYes
Pollution degree per EN 61800-5-12 (non-conductive pollution)
Напряжение питанияIII
Degree of protection per EN 60529IP20
Storage5 to 95%
Transport95% at 40°C
Operation5 to 85%, non-condensing
Width66 mm
Height374 mm
Wall mounting258.5 mm (with 8EXA front cover: 261 mm)
Масса4 kg
Получить предложение по этой позиции