ebm-papst Mulfingen GmbH & Co. KG D3G318-BB35-01
EC centrifugal fan
Категории:
Технические характеристики
| Масса | 23,1 kg |
|---|---|
| Motor size | 112 |
| Size | 318 mm |
| Rotor surface | Painted black |
| Материал | Die-cast aluminum |
| Материал | Sheet steel, galvanized |
| Материал | Sheet steel, galvanized |
| Motor suspension | Motor vibration-damped on both sides |
| Direction of rotation | Clockwise, viewed toward rotor |
| Degree of protection | IP54 |
| Insulation class | "B" |
| Moisture (F) / Environmental (H) protection class | H1 |
| Max. permitted ambient temp. for motor (transport/storage) | +80 °C |
| Min. permitted ambient temp. for motor (transport/storage) | -40 °C |
| Installation position | Shaft horizontal |
| Condensation drainage holes | None |
| Mode | S1 |
| Motor bearing | Ball bearing |
| Technical features | - Output 10 VDC max. 10 mA - Tach output - Alarm relay - Integrated PID controller - Motor current limitation - PFC, passive - RS-485 ebmBUS - Soft start - Control input 0-10 VDC / PWM - Thermal overload protection for electronics/motor - Undervoltage detection |
| EMC immunity to interference | According to EN 61000-6-2 |
| EMC circuit feedback | According to EN 61000-3-2/3 |
| EMC interference emission | According to EN 61000-6-4 (industrial environment) |
| Touch current according to IEC 60990 (measuring circuit Fig. 4, TN system) | <= 3,5 mA |
| Motor protection | Thermal switch auto reset, internally connected |
| with cable | Variable |
| Protection class assignment | I; If a protective earth is connected.|The built-in component has several local protection class assignments.|The final protection class is determined by the intended installation. |
| Conformity with standards | EN 61800-5-1 / CE |
| Approval | EAC |
| Phase | 3~ |
| Напряжение питания | AC |
| Напряжение питания | 400 V |
| Напряжение питания | 380 .. 480 V |
| Frequency | 50/60 Hz |
| Type of data definition | maximum load |
| Speed | 880 min-1 |
| Power input | 1000 W |
| Current draw | 1,7 A |
| Min. back pressure | 150 Pa |
| Рабочая температура | -25 °C |
| Рабочая температура | 40 °C |