ebm-papst Mulfingen GmbH & Co. KG K3G250-RR01-H1
EC centrifugal module - RadiCal
Категории:
Технические характеристики
| Масса | 5,46 kg |
|---|---|
| Motor size | 84 |
| Size | 250 mm |
| Rotor surface | Painted black |
| Материал | Die-cast aluminum, painted black |
| Материал | PA plastic, sheet-metal plate painted black |
| Материал | Sheet aluminum |
| Материал | Aluminum |
| Материал | Sheet aluminum |
| Материал | Steel, coated with white-aluminum plastic (RAL 9006) |
| Number of blades | 7 |
| Direction of rotation | Clockwise, viewed toward rotor |
| Degree of protection | Motor IP55, electronics IP20 |
| Insulation class | "F" |
| Moisture (F) / Environmental (H) protection class | H0 - dry environment |
| Max. permitted ambient temp. for motor (transport/storage) | +80 °C |
| Min. permitted ambient temp. for motor (transport/storage) | -40 °C |
| Installation position | Shaft horizontal or rotor on top; rotor on bottom on request |
| Condensation drainage holes | On rotor side |
| Mode | S1 |
| Motor bearing | Ball bearing |
| Technical features | - Output 10 VDC, max. 10 mA - Operation and alarm display with LED - Alarm relay - Integrated PID controller - Power limiter - Motor current limitation - PFC, active - RS-485 MODBUS-RTU - Soft start - Control input 0-10 VDC / PWM - Control interface with SELV potential safely disconnected from the mains - Thermal overload protection for electronics/motor - Line undervoltage / phase failure detection |
| EMC immunity to interference | According to EN 61000-6-2 (industrial environment) |
| EMC circuit feedback | According to EN 61000-3-2/3 |
| EMC interference emission | According to EN 61000-6-3 (household environment) |
| Touch current according to IEC 60990 (measuring circuit Fig. 4, TN system) | <= 3,5 mA |
| Electrical hookup | Plug |
| Motor protection | Thermal switch auto reset, internally connected |
| Protection class assignment | I; If a protective earth is connected.|The built-in component has several local protection class assignments.|The final protection class is determined by the intended installation. |
| Conformity with standards | EN 61800-5-1 / CE |
| Approval | UL 507 / CSA C22.2 No. 113 |
| Phase | 1~ |
| Напряжение питания | AC |
| Напряжение питания | 230 V |
| Напряжение питания | 200 .. 277 V |
| Frequency | 50/60 Hz |
| Type of data definition | maximum load |
| Speed | 3600 min-1 |
| Power input | 480 W |
| Current draw | 2,1 A |
| Рабочая температура | -25 °C |
| Рабочая температура | 60 °C |