ebm-papst Mulfingen GmbH & Co. KG W3G630-KE55-53
EC axial fan - AxiCool
Категории:
Технические характеристики
| Масса | 20,6 kg |
|---|---|
| Motor size | 112 |
| Size | 630 mm |
| Rotor surface | Painted black |
| Материал | Die-cast aluminum, painted black |
| Материал | Press-fitted sheet steel blank, sprayed with PP plastic |
| Материал | PP plastic |
| Материал | PP plastic |
| Материал | Steel, coated with black plastic (RAL 9005) |
| Number of blades | 5 |
| Airflow direction | V |
| Direction of rotation | Counterclockwise, viewed toward rotor |
| Degree of protection | IP55 |
| Insulation class | "F" |
| Рабочая температура | If there is a risk of ice formation, the fan is only to be operated with a heating tape in the fan housing. Further information can be obtained from ebm-papst. As fan only suitable for use with industrial evaporators |
| Moisture (F) / Environmental (H) protection class | H2 |
| Max. permitted ambient temp. for motor (transport/storage) | +70 °C |
| Min. permitted ambient temp. for motor (transport/storage) | -40 °C |
| Installation position | See fitting instructions |
| Condensation drainage holes | On rotor side |
| Mode | S1 |
| Motor bearing | Ball bearing with low-temperature lubricant |
| Technical features | - Output 10 VDC, max. 10 mA - Operation and alarm display - External 24 V input (parameter setting) - Alarm relay - Integrated PID controller - Motor current limitation - PFC, passive - RS-485 MODBUS-RTU - Soft start - EEPROM write cycles: 100,000 maximum - Control input 0-10 VDC / PWM - Control interface with SELV potential safely disconnected from the mains - Thermal overload protection for electronics/motor - Line undervoltage / phase failure detection |
| Touch current according to IEC 60990 (measuring circuit Fig. 4, TN system) | <= 3,5 mA |
| Motor protection | Thermal switch auto reset, internally connected |
| Protection class assignment | I; If a protective earth is connected.|The built-in component has several local protection class assignments.|The final protection class is determined by the intended installation. |
| Conformity with standards | EN 61800-5-1 / CE |
| Approval | EAC / CSA C22.2 No. 77 + CAN/CSA-E60730-1 / UL 1004-7 + 60730-1 |
| Phase | 3~ |
| Напряжение питания | AC |
| Напряжение питания | 400 V |
| Напряжение питания | 380 .. 480 V |
| Frequency | 50/60 Hz |
| Type of data definition | maximum load |
| Speed | 1000 min-1 |
| Power input | 640 W |
| Current draw | 1 A |
| Max. back pressure | 150 Pa |
| Рабочая температура | 40 °C |