Pepperl+Fuchs SE NAB10-30GM50-I-V1
Inductive sensor
Категории:
Технические характеристики
| Output type | 4 ... 20 mA |
|---|---|
| Installation | flush |
| Output polarity | DC |
| Actuating element | mild steel, e. g. 1.0037, SR235JR (formerly St37-2)30 mm x 30 mm x 1 mm |
| Measuring range | 0 ... 10 mm |
| Напряжение питания | 15 ... 30 V |
| Reverse polarity protection | reverse polarity protected |
| Short-circuit protection | current limited |
| Linearity error | ± 3 % of full-scale value |
| Temperature drift | ± 10 % of full-scale value |
| Repeat accuracy | ± 1 % of full-scale value |
| Recovery time | ≤ 50 ms |
| No-load supply current | 12 mA |
| Status indicator | Multihole-LED, yellowpermanently on: damping element within measuring rangeslowly flashing (2 Hz): damping element outside measuring rangefast flashing (10 Hz): fault state |
| MTTFd | 929 a |
| Mission Time (TM) | 20 a |
| Diagnostic Coverage (DC) | 0 % |
| Slope of output characteristic | 1.6 mA / mm |
| Load resistor | ≤ 500 Ω |
| Settling time | ≤ 100 ms |
| PWIS conformity | VDMA 24364-A1/B2/C1/T100°C-W |
| Standard conformity - Standards | EN IEC 60947-5-2EN IEC 60947-5-7 |
| Protection class | II |
| Напряжение питания | 30 V |
| Напряжение питания | 500 V |
| UL approval | cULus ListedLoad Type: General PurposeCircuitry: Class 2 Power SourceEnclosure Type Rating: Type 1Supply/Switching Voltage: 30 V DC |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Рабочая температура | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Connection type | Connector plug |
| Материал | brass , white bronze coated |
| Sensing face | PBT , green |
| Degree of protection | IP65/IP67/IP68 |
| Connector - Threading | M12 x 1 |
| Connector - Number of pins | 3 |
| Mass | 153 g |
| Dimensions - Length | 67 mm |
| Dimensions - Diameter | 30 mm |
| Mounting | with nuts, M30 |
| Tightening torque | ≤ 30 Nm |
| Scope of delivery | 2 self locking nuts in scope of delivery |