Pepperl+Fuchs SE NAB4-12GM30-E2-IO
Inductive sensor
Категории:
Технические характеристики
| Switching function | Normally open/closed (NO/NC) programmable |
|---|---|
| Output type | PNP |
| Installation | flush |
| Output polarity | DC |
| Actuating element | mild steel, e. g. 1.0037, SR235JR (formerly St37-2)12 mm x 12 mm x 1 mm |
| Measuring range | 0 ... 4 mm |
| Напряжение питания | 10 ... 30 V (SIO mode)18 ... 30 V (IO-Link) |
| Switching frequency | SIO mode: 1200 Hz (high speed filter) |
| Hysteresis | 1 ... 20 % ( factory setting: 5 % ) |
| Reverse polarity protection | reverse polarity protected |
| Short-circuit protection | pulsing |
| Напряжение питания | ≤ 1 V |
| Linearity error | ± 3 % of full-scale value |
| Temperature drift | ± 10 % of full-scale value |
| Repeat accuracy | ± 1 % of full-scale value |
| Speed measuring range | 1 ... 1400 mm/s |
| Speed measurement accuracy | ± 20 % of the full-scale value |
| Speed measurement repeat accuracy | ± 5 % of the full-scale value |
| Operating current | 0 ... 100 mA |
| Off-state current | max. 30 µA |
| No-load supply current | 17 mA |
| Time delay before availability | max. 100 ms |
| Switching state indicator | LED, yellowpermanently on: switching ouput activepermanently off: switching output inactivefast flashing (10 Hz): fault state |
| MTTFd | 1410 a |
| Mission Time (TM) | 20 a |
| Diagnostic Coverage (DC) | 0 % |
| Interface type | IO-Link ( via C/Q = pin 4 ) |
| IO-Link revision | 1.1 |
| Device profile | Identification and Diagnosis - I&DSmart Sensor - SSP 0Smart Sensor - SSP 4.1.1 |
| Process data | Input: 32 Bit- measurement value 16 Bit- scaling 8 Bit- Diagnosis signals 3 Bit- switching signals 2 Bit |
| Vendor ID | 1 (0x0001) |
| Device ID | 2098947 (0x200703) |
| Transfer rate | COM2 (38.4 kBit/s) |
| Min. cycle time | 3.2 ms |
| SIO mode support | yes |
| Compatible master port type | Class A , Class B |
| PWIS conformity | VDMA 24364-C1/T100°C-W |
| Standard conformity - Standards | EN IEC 60947-5-2EN IEC 60947-5-7 |
| Protection class | II |
| Напряжение питания | 30 V |
| Напряжение питания | 500 V |
| UL approval | cULus ListedLoad Type: General PurposeCircuitry: Class 2 Power SourceEnclosure Type Rating: Type 1Supply/Switching Voltage: 30 V DCOutput Switching Current: 100 mA |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Рабочая температура | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Connection type | cable |
| Материал | brass , white bronze coated |
| Sensing face | PBT , green |
| Degree of protection | IP65 / IP67 |
| Cable - Wire end ferrules | yes |
| Cable - Cable diameter | 4.3 mm ± 0.15 mm |
| Cable - Bending radius | > 10 x cable diameter |
| Материал | PVC |
| Cable - Color | black |
| Cable - Number of cores | 3 |
| Cable - Core cross section | 0.34 mm2 |
| Cable - Length | 2 m |
| Mass | 67 g |
| Dimensions - Length | 33 mm |
| Dimensions - Diameter | 12 mm |
| Mounting | with nuts, M12 |
| Tightening torque | ≤ 10 Nm |
| Scope of delivery | 2 self locking nuts in scope of delivery |