Pepperl+Fuchs SE NJ15-M1K-N
Inductive sensor
Категории:
Технические характеристики
| Switching function | Normally closed (NC) |
|---|---|
| Output type | NAMUR |
| Rated operating distance | 15 mm |
| Installation | non-flush |
| Assured operating distance | 0 ... 12.15 mm |
| Actual operating distance | 13.5 ... 16.5 mm typ. |
| Reduction factor rAl | 0.45 |
| Reduction factor rCu | 0.4 |
| Reduction factor r304 | 0.8 |
| Напряжение питания | 8.2 V (Riapprox. 1 kΩ) |
| Switching frequency | 0 ... 100 Hz |
| Current consumption - Measuring plate not detected | min. 3 mA |
| Current consumption - Measuring plate detected | ≤ 1 mA |
| Switching state indicator | LED, yellow |
| MTTFd | 2424 a |
| Mission Time (TM) | 20 a |
| Diagnostic Coverage (DC) | 0 % |
| Standard conformity - NAMUR | EN 60947-5-6:2000IEC 60947-5-6:1999 |
| Standard conformity - Electromagnetic compatibility | NE 21:2012 |
| Standard conformity - Standards | EN IEC 60947-5-2 |
| IECEx approval - Equipment protection level Ga | IECEx PTB 11.0021X |
| IECEx approval - Equipment protection level Gb | IECEx PTB 11.0021X |
| IECEx approval - Equipment protection level Da | IECEx PTB 11.0021X |
| IECEx approval - Equipment protection level Mb | IECEx PTB 11.0021X |
| ATEX approval - Equipment protection level Ga | PTB 00 ATEX 2032 X |
| ATEX approval - Equipment protection level Gb | PTB 00 ATEX 2032 X |
| ATEX approval - Equipment protection level Da | PTB 00 ATEX 2032 X |
| UL approval | cULus ListedCircuitry: Class 2 Power SourceEnclosure Type Rating: Type 1Supply/Switching Voltage: 8.2 V DC |
| ATEX approval - Ordinary Location | E87056 |
| ATEX approval - Hazardous Location | E501628 |
| ATEX approval - Control drawing | 116-0451 |
| CCC approval - Hazardous Location | 2020322315002302 |
| CML approval | on request |
| ANZEx | 19.3001X |
| Рабочая температура | -25 ... 100 °C (-13 ... 212 °F) |
| Connection type | screw terminals |
| Information for connection | A maximum of two conductors with the same core cross section may be mounted on one terminal connection!tightening torque 1.2 Nm + 10 % |
| Core cross section | up to 2.5 mm2 |
| Minimum core cross-section | without wire end ferrules 0.5 mm2, with connector sleeves 0.34 mm2 |
| Maximum core cross-section | without wire end ferrules 2.5 mm2, with connector sleeves 1.5 mm2 |
| Материал | PBT |
| Sensing face | PBT |
| Degree of protection | IP67 |
| Dimensions - Height | 30 mm |
| Dimensions - Width | 30 mm |
| Dimensions - Length | 91 mm |
| Use in the hazardous area | see instruction manuals |