Pepperl+Fuchs SE UDC-18GS-3EP-IO-0,2M-V19-P001
Double Sheet Sensor Kit
Категории:
Технические характеристики
| Sensing range | 20 ... 60 mm , optimal distance: 45 mm |
|---|---|
| Transducer frequency | approx. 255 kHz |
| Non-volatile memory | EEPROM |
| Write cycles | 300000 |
| LED green | indication: single sheet detectedflashing (1 Hz) - standby modeflashing with short break (1 Hz) - IO-Link mode |
| LED yellow | indication: no sheet detected (Air) |
| LED red | indication: double sheet detectedflashing: device error |
| Напряжение питания | 18 ... 30 V DC , ripple 10 %SS |
| No-load supply current | ≤ 40 mA |
| Power consumption | ≤ 550 mW |
| Time delay before availability | ≤ 300 ms |
| Interface type | IO-Link |
| IO-Link revision | 1.1 |
| Device profile | Identification and Diagnosis - I&D |
| Process data | Input: 16 Bit- measurement value 8 Bit- selected threshold set 2 Bit- switching signals 3 Bitoutput: 8 Bit- threshold set 2 Bit- disable transducer 1 Bit |
| Vendor ID | 1 (0x0001) |
| Device ID | 3148289 (0x300A01) |
| Transfer rate | COM2 (38.4 kBit/s) |
| Min. cycle time | 2.8 ms |
| SIO mode support | yes |
| Compatible master port type | Class A (use adapter cable listed in accesories)Class B (use 3-pole adapter or 3-wire cable) |
| Designation | OUT 1 ... 3 |
| Input/output type | input or output programmable via IO-Link :input for selection of a threshold set (factory default)output as feedback output |
| 0 Level | 0 ... 1 V |
| 1 Level | 2.5 V ... UB |
| Input impedance | ≥ 60 kΩ |
| Output current | current source < 2.5 mA |
| Pulse length | ≥ 100 ms |
| Synchronization frequency - Common mode operation | ≤ 230 Hz |
| Synchronization frequency - Multiplex operation | ≤ 230 Hz /n, n = number of sensors , n ≤ 10 |
| Input type | 0-level: 0 ... + 1V1-level: +UB- 1 V ... +UB |
| Signal | 0-level: 0 ... + 1V1-level: +UB- 1 V ... +UB |
| Output type | Push-pull (4 in 1) output , NO contact ( programmable ) |
| Rated operating current | 100 mA per output |
| Напряжение питания | ≤ 3 V |
| Fusing | reverse polarity protected , overload and short-circuit resistant |
| Impedance | ≥ 60 kΩ |
| Number | 3 |
| Output function | OUT 1: single sheet detectedOUT 2: double sheet detectedOUT 3: no sheet detected (air) |
| Switch-on delay | 15 ms (programmable) |
| Switch-off delay | 15 ms (programmable) |
| Pulse extension | can be activated (100 ms or IO-Link cycle time) |
| Standard conformity - Standards | EN IEC 60947-5-2:2020IEC 60947-5-2:2019IEC 61131-9 / IO-Link V1.1.3 |
| UL approval | cULus Listed, General Purpose, Class 2 Power Source |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Рабочая температура | 0 ... 60 °C (32 ... 140 °F) |
| Storage temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Connection type | fixed cable with plug |
| Housing length ultrasonic - Ultrasonic transmitter | 21 mm |
| Housing length ultrasonic - Ultrasonic receiver | 52 mm |
| Housing diameter ultrasonic - Ultrasonic transmitter | 18 mm |
| Housing diameter ultrasonic - Ultrasonic receiver | 18 mm |
| Degree of protection | IP65 |
| Материал | Stainless steel 1.4305/AISI 303, polyamide plastic parts |
| Материал | epoxy resin/hollow glass sphere mixture; polyurethane foam |
| Connector - Threading | M12 x 1 |
| Connector - Number of pins | 8 |
| Cable - Cable diameter | 4.3 mm |
| Cable - Bending radius | 5 x diameter , fixed installation |
| Материал | PUR |
| Cable - Color | black |
| Cable - Length | approx. 200 mm |
| Mass | 75 g |
| Tightening torque, fastening screws | max. 20 Nm |